Convert CATPART to 3DMAP

File Extension CATPART
Full Name CATIA Part Format

File with a .CATPART extension contains geometric and structural data of a 3D model of a complete project of a product. As a result of connecting many CATPART files of a given product – a .CATPRODUCT may be created.

File Extension 3DMAP
Full Name CATIA 3dmap

What is file format conversion?

File format conversion is the process of transforming a file from one format (referred to as "CATPART") to another (referred to as "3DMAP"). This may be necessary for various reasons. For example, CATPART file may be incompatible with the software or device we want to use to open or edit it. In such cases, converting the file from format CATPART to format 3DMAP becomes essential.

So, how can we perform CATPART to 3DMAP file conversion? Fortunately, there are many tools and computer programs available that enable file format conversion. These tools work by reading the data from the file in format CATPART and transforming it into format 3DMAP. This allows the preservation of the original information contained in the file, even after changing its format. Below you will find a list of CATPART to 3DMAP converters.

Conversion from CATPART to 3DMAP

CATPART to 3DMAP

How to convert the CATPART file to 3DMAP?

If you have already downloaded one of the converters and installed it on your computer, you can proceed to the appropriate conversion process of CATPART to 3DMAP. Handling all the programs is usually very intuitive and is based on the same pattern of conduct. We will briefly discuss a few steps that you always need to go through while changing the format of the CATPART file:

  • Please indicate on your computer the source file CATPART, the format of which you are going to change
  • Load the CATPART file to the application
  • Select the output format of the 3DMAP file (the one that we want to achieve)
  • Select the location to save the output file 3DMAP on the disk (the place where the program will save the converted file)
  • Confirm conversion
  • Wait for a moment
  • Enjoy the converted 3DMAP file that can be found in the location selected in step 4
I cannot see the file extensions. What should I do?

File extensions are not normally displayed to users. To change this, go to Control Panel, select Appearance and Personalization and Folder Options. Next, select the View and find the option "Hide extensions for known file types". The option should be deselected (cleared) and confirmed with OK.